Questions about cnc level of detail

[jast]

Kee Fedak probably did the most detailed work on the multicam that has been done at DMS, so searching the forum for his work might be helpful…
Here’s one example…

Dallas Makerspace Show & Tell - June 2018

3D Scan, Upscale and Sand Casting of Backplate and Spout. Original object was 6x6 Inches [1] I 3D scanned the original, clean up the model and defined features in software. I upscaled the model and cut out the new and improved model on the CNC. [Screenshot_3] I then built a pattern board to be sand casted in brass. [2] [3] Backplate and spout were cast at a foundry. Here is the finished casting. It’s 10x10 inches [4] [5] Two of them were installed in a new home being built locally…