I have owned this truck for 10 years, but I just don’t have the time or motivation to finish it. Clean title! I have barely done anything to this truck in the last 5 years, so my memory is hazy, but here’s a run-down of what you’re looking at:
-Engine: came from a '68 C-10 that has about 10k miles since being freshened up by the previous owner (rings, gaskets, etc.). Has electronic ignition, Rochester 1 bbl carburetor, starts and runs smoothly.
-Driveline: Clutch and throwout bearing are new, 3-speed transmission works as it should, rear-end pinion seal is new
-Brakes: original manual drum brakes all around. Shoes and wheel cylinders were replaced when I first got the truck, and still work, but its been sitting and the LF is dragging now
-Suspension: 6 lug, lower control arms have been stepped 1.5", 3" drop coils, new shocks all around, new tie-rod ends, and new upper/lower ball joints. C-notched frame with air bags in the rear.
-Interior: Instrument cluster has been cleaned and painted but is not installed, has 60/40 split bench from a '90s pickup installed but I have the original bench seat to go with the truck.
-Body: All glass is there, needs fresh seals. Needs body work and is rusted through in places, this is where the project stalled out for me. I do not have the bed, my plan was to build a flat bed.
-Wheels: 4 brand new smoothie wheels, 15x6, painted gloss black. Front tires have no miles, but are a few years old now.
-Misc: I have some assorted parts to go with the truck, including the heater box, some trim pieces, a hood, bed support rails, a worn out 230ci L6 engine, etc.
The truck starts, runs, drives, and stops, but is not yet road worthy. Clean title. Good project truck. Located in Denton. Asking $2900 OBO.
http://images.craigslist.org/00G0G_cYXFT1jHwbo_600x450.jpg
http://images.craigslist.org/00o0o_aWROPbFTx1Y_600x450.jpg