Would anyone be available for a few minutes to help me get started on a plasma cutter cut?
I think I know what I’m doing but I’m not sure it’s a good idea to just let me loose on it without at least some initial supervision. 
- I’ve been trained (very recently, and twice)
- I have very good notes that I have been re-reading
- I have the material (14ga mild steel) and new fine cut consumables
- I have programmed it using Sheet Cam and the post-processor didn’t find any errors
So, in short, I think I’m ready but I’m seeking that little bit of safety blanket.
I’m not in a hurry and I can fit the schedule of anyone who is willing/available to help.