Jewelry Casting

[jast]

@MadScists

If training is required, is there going to be any classes coming up because I have not actually ever seen one on the calendar as far as I can remember.

Like this one?
https://calendar.dallasmakerspace.org/events/view/18582

I think that’s what you’re after…

As for the rest…
Chris did a pretty extensive writeup here that might get the wheels spinning.

My First 3-D Printing Project Assistance Needed

Recommendations from the wax manufacturer (Senertek): PLASTICAST (an R & R investment) Mix the investment with 39 parts distilled water with 100 parts investment (39mls water per 100g of powder). You can also test with 36:100 ratio. Mix as long as possible for maximum strength. Adding 0.5% - 2% boric acid in the investment powder can create better surface quality. Just mix boric acid 1% with 60 degree water (140o F); dissolve it as you dissolve sugar in water. Let the water come to 50 degree…

OH, and congrats on the new baby…

@MadScists

I ended up leaving with a Creality LD-002R