Dynatorch computer?

Metal Shop
1

What does it take to wake up the Dynatorch computer? Light is on on the computer brick but monitor says No signal. Thx.

2

Turn the power off, wait several seconds (literally, several) and then power it on again. Wait several seconds. If it still appears to have no intention of booting into Windows, hold the power button for a few seconds to power it off. Then wait several seconds and power it on again.

2 Likes
3

Thanks mucho!! Second try worked.

4

Also … I walked away from the computer for just a couple minutes while I was doing my SheetCam “programming”. It “went to sleep” and could not be roused except using a cold boot.

Can it fall asleep like that while cutting?