Came in to do some machining and saw all the pressure gauges were at 0psi, so I went to see if there was a crowd around the electrical room (there wasn’t), but the room door was open, so, maybe the compressor is getting some TLC?
Not sure but I didn’t see a notice about this anywhere so I suspect it’s unintended.
It’s running
There’s a post here: https://talk.dallasmakerspace.org/t/march-28-2024-11-30-am-no-air-pressure/107462/4
But, that’s in a member’s only category. You can make a post here (Member Access (Green Dot) - Dallas Makerspace Talk) to get access to it.
Yeah, you have to make a post in that green dot category, then one of the talk volunteers will add the permissions to your account.
Go to this category, create a new topic, and follow the instructions. Should take you about 2 minutes or less.
