Fwd: 2" Focus Ruler for Pro LF Series 36x24 CO2 Laser

[LisaSelk]

There should be an .XPS file attached to use to cut a new Focus Ruler for
our laser. Please let me know if it gets stripped from the message (I
wasn’t able to upload it directly from the web interface of the forum, so I
am forwarding the message I received the file on to see if it will remain
‘attached’ in the forum…).

If it gets stripped, I’ll upload it to the wiki later this afternoon.

Please see the following post for instructions on how to use the focus
ruler to manually focus the laser:

Recommended Method: How to focus our Full Spectrum ProLF 36x24 Laser Cutter/Engraver

Please review page 30 of the Full Spectrum ProLF 36x24 Laser Manual for instructions on how to Manually Focus the laser cutter/engraver: http://fslaser.com/files/36-48pro_manual.pdf I have sent a request to Full Spectrum for the file to cut a new focus ruler - to be sure of the accuracy; but, I’m not sure how long it will take to get a response. I will try to cut a new Focus Ruler to be used later tonight to at least give us something to aim for. As soon as I get a copy of the actual file and…

Thanks!
Lisa

[LisaSelk]

Try this and let me know if it works:

File:62mm_Pro_2in.pdf

“This is the file (converted from XPS to PDF in order to upload it) that
was sent to us by Full Spectrum to use to cut a new 2” Focus Ruler for our
Full Spectrum Pro LF Series 36x24 CO2 Laser cutter / engraver."