Polyprinter and Elegoo Training Question

3D Fabrication
1

I took the old Polyprinter class on 8/25/16 and the Form2 class on 4/8/17. I used these printers countless times from 2016 through Covid. I then purchased my own 3D printer and have not needed to use the DMS printers for several years. I now have need to do so again, so I took the online training for both printers and passed both quizzes with a 100%.

Is there anything else I need to do, or when I come in this weekend will I be fully approved to use both type of printers?

2

Unless something has been changed without publishing it … you’re good to go.

3

You should be able to log into the Octoprint servers which control the PolyPrinters after completing the online training and quiz with a passing score. The resin printers require completing the relevant online training unless something has changed recently.