New printers installed with Octoprint

3D Fabrication
1

We got new Pi 3’s on the new Polyprinters and did some much needed wire management back there. Waiting on brooks to get IP addresses reserved for the pis and they’ll be available on all the computers.

IMG_20161213_043245413.jpg2518×3357 2.06 MB

UTA’s fab lab released a modified version of Octoprint and I will be looking into adopting it to our back end system. They even have fancy thermal paper receipts printed for each 3D print job.

6 Likes
2

So you guys can use it, here’s the current IP addresses to access Octoprint (you will need to go to these IP addresses on firefox or chrome, not IE)

Center Righty: currently on 192.168.203.85

Center Lefty: currently on 192.168.205.11

2 Likes
3

The static IP addresses have been set.

I used the names that Mitch referred to on this TALK post for reference…

Center Lefty - 192.168.200.101 (official name and color TBD)
Center Righty - 192.168.200.102 (official name and color TBD)

NOTE: As Mitch mentioned - even though the static IPs have been set, you will still need to enter the IP Address into the address bar of Firefox (_or Chrome, if it's working with Octoprint now..._). I imagine that Axie & Mitch will probably hold off setting the shortcuts to use the 'hostname' - until after a final name has been determined for them...
1 Like
4

that is correct, still waiting until contest is done before we put octoprint onto the screens.

also .101’S official color is red,
.102’s printer color is pink. but since octoprint doesn’t have pink as an option its color is black…pink/black

5

This is awesome. Thanks for the hard work, guys!