Was helping a guy attempt to flatten a piece. We were just setting the z off what looked like the highest place, running the toolpath, adjusting z and running again. Rinse and repeat till flattish. The first pass started cutting a little deep in a place I didn’t expect, and dislodged the workpiece.
We reset and continued to make multiple successful passes until we went to set the height one time and Z no longer would move.
ISSUE or REQUEST:
Affected Tool or Resource:
Committee, Group or Volunteer who usually handles this type of ISSUE or REQUEST (Please tag using the @ symbol. A list of current groups that can be “mentioned” is maintained at this LINK.):
Details of ISSUE or REQUEST (Please be as specific as possible):
PLEASE REMEMBER DALLAS MAKERSPACE IS AN ALL VOLUNTARY RUN COMMUNITY.
Our volunteers will handle the reported issues as quickly as possible; however, there is no guaranteed time frame for resolution - due to the voluntary nature of how things work around here.
Please consider volunteering to help maintain some of our resources to help keep things running as smooth as possible here! Thanks!
:bulb: **If you are reporting or resolving an equipment issue, please also update the [tool status board](https://dallasmakerspace.org/cgi-bin/toolstatus.cgi) appropriately.**
:warning: **NOTE**: This category is **NOT** for discussion threads. Any "discussion" will be split out by one of the TALK Moderators to create a separate "discussion thread".