MultiCam - To All The Jackasses

Who keep putting screws through the MDF spoilboard and into the vacuum table - stop.

I scraped the entire Phenolic table yesterday because every time you put a screw through it you leave a little lip in the Phenolic table. This little lip raises up the MDF spoilboard and cause the vacuum to leak. This was a major contributer to the reason the vacuum hold down has been terrible lately.

This is also ignoring the fact that it damages the table in other ways as well.

Measure your screw, double check it, stop being so lazy.

16 Likes

This post was flagged by the community and is temporarily hidden.

8 Likes

Can one infer that the “Jackasses” are screwing everybody who uses the Multi-cam? :smiley: