MultiCam is down (FIXED AS OF 9/28)

Woodshop
1

Per @AlexRhodes (in a separate post), the MultiCam is down.

I assume this means that regular Thursday night testing will not occur tomorrow night?

1 Like
2

The multicam is down as well… this tells me we should not depend on a single CNC router :wink:

3 Likes
3

I have updated the Tool Status board to show the MultiCam as down. If you can give me more info (needs review, part broken, repair scheduled, etc.) I can update the sub-category.

4

Spindle and z axis sound awful. Plan is to call Multicam and Perske (spindle Manufacture) tomorrow.

4 Likes
5

Too bad we do not have a spare in the Vintage Computer Museum…

1 Like
6

Chris (@John_Marlow) ~ Thank you for creating a new thread for this issue. I have moved the related posts from the other thread into this one - where they better belong.

1 Like
7

Any luck on getting this serviced? I was going to try and test out on Thursday if it was.

Thanks.

8

It got some TLC from a few people (@Chris_Wischkowsky and @Tapper) and is up now.

5 Likes
9

Not sure fixed is the right word. We’re watching it, but suspect we’re starting to lose the bearings on the spindle.

1 Like
10

Thank you very much guys!

11

I have marked it as Operational (green) in the Tool Status Board, but have included the sub-status “Needs review by tool expert”.

12

So… green with yellow highlights?

2 Likes