I'm not sure - but I think I like it

7 Likes

English or metric?

2 Likes

Now that is just creepy. This what happens when you let non-moon walker tools in,

2 Likes

Brings new meaning to ‘finger tight’

2 Likes

what’s metric?

it’s got enough defects in it that i’m thinking it might be 3d printed.

Short lived fad.

2 Likes

Tools by H. R. Giger…

1 Like

definitely not by King Dick!

you had to go there…LOL!!!

1 Like

KIng DIck - real tools and the oldest tool manufacturer in Britain.

But yes, I did have to go there!

1 Like

At least it is not in the form of “The Shocker”

3 Likes

We still wouldn’t let one of our guys buy one. We banned him from getting anything larger than an 8” crescent wrench.

1 Like

I wouldn’t get caught dead turning my nuts with one of those!

5 Likes

<8" doesn’t offer enough torque to round off the nut/bolt head?

Grade 8? :blankspace:

He broke a forged flare nut and broke the copper flare as well with a 12”. It was kinda to make a point. Here is this 6’3 dude 375lbs with a small 8” crescent.

1 Like

… releasing all of the coolant and turning a 30 minute job into an 8 hour job?

1 Like

Not all of it. It was a low pressure machine but it was on the high side. So when it was running it was leaking R-123, then when it was off sucking air. The bad thing is when you suck a low pressure machine full of air, it takes days to get it back out. A lot of babysitting, the purge is powered by the machine, so if it isn’t running, it’s not purging air out.

Also his nick name was Mongo.

1 Like
2 Likes