I’ve been trying to install an SKR 2 on my Ender 5 plus, but as far as I can tell my firmware isn’t working. I’m not sure what I’m doing wrong.
Is there anyone that would be willing to help me figure this out?
Can you be more specific about the “not working” part? I recently swapped a SKR 1.4 Turbo into my homebuilt RepRap.
Are you having issues compiling the firmware? Which firmware?
Or is it a “printer doesn’t respond” kind of thing?
ETA: you might try the Reddit group for BTT as well: https://old.reddit.com/r/BIGTREETECH/
The TFT35 is working fine, but it doesn’t detect the mainboard. It says no printer detected.
My best guess is that my firmware is wrong, but I’ve been through the subreddit and tried everything that I could find. I’m wondering if the board is DOA, but I don’t know how to verify that.
Disconnect everything but power and turn it on, look at the LED(s). I had an endstop wired wrong on mine and it caused a boot failure. It would boot without the endstop connected, but when I hooked up the endstops it wouldn’t do anything.