Bubba hotend not heating

[Carter_Pollan]

I was attempting to use Bubba to print tonight. I set the hotend to ABS to do a purge and about 3 minutes into heating up the hotend stopped heating and cooled off. I tried turning it on and off again a few times online with no change. The bed got up to temp just fine and I could see no errors in the terminal.

Attached is a screenshot of the temperature panel for reference.

I apologize for not using the #issues-requests as indicated but I couldn’t find it for the life of me. I can re-post there if

[bitta]

@Team_3D_Fab

[ozindfw]

@Carter_Pollan

apologize for not using the Issues & Requests as indicated but I couldn’t find it for the life of me.

You could not find Issues and Requests because Talk does not recognize you as a member and give you access to DMS-only categories. See About the Member Access (Green Dot) category and apply for a Green Dot.