Bubba down, abs not sticking to the bed

3D Fabrication
#1

Bubba and most of the other 3d printers appears to be down. Filament is coming out, but not adhering to the bed

#2

@Team_3D_Fab

1 Like
#3

I don’t know your experience level, so forgive me if I’m assuming too little about your experience.

. . . . but have you checked the Kisslicer settings to be sure you’ve set it for ABS and not PLA?

If that’s not the issue, maybe it’s a bed-leveling issue.

#4

A post was merged into an existing topic: Want to come pay for my first month

#5

Yes, my settings are correct. It does seem like a bad level issue, a problem I’m not checked out to fix.