ATTENTION: The three PolyPrinters that are set up for printing ABS will be reserved for testing on Sunday, April 12th from 12:00 PM (noon) until the testing is complete in the evening

[LisaSelk]

ATTENTION:

The three PolyPrinters that are set up for printing ABS will be reserved for testing on Sunday, April 12th from 12:00 PM (noon) until the testing is complete in the evening.

The only 3D printer that will be available for general use on Sunday will be “Lefty” which is currently configured to print NinjaFlex.

For more information about the testing, please check out the following thread on our TALK forums:

Remote Surveillance of 3d printers

I would like to initiate structured discussions on the remote Surveillance of 3d printers. The purpose of this post is not evaluate the feasibility or merits of setting up a streaming process for print surveillance, but rather to gain technical knowledge about how something like this is set up. To ensure that this post effectively and efficiently communicates such processes , I would encourage everyone to refrain from referencing,addressing, or criticizing the ideas of others. Instead, this th…

Thank you,
Lisa
3D Fab Chairperson