For quite a while, I have been wanting to try an inlay using the MultiCam CNC but had other projects going. I choose to use the logo of the program I direct at SMU as a “little” test. The board is about 16 inches wide and 6 inches tall made from an oak short and walnut. Didn’t turn out perfectly, but I definitely learned some tips for next time. Biggest lessons are to use a ton of glue and then let it dry with the inlay (the walnut in this case) on the bottom so the majority of the glue runs to the scrap.
After cutting the excess off on the band saw:
Finished product hanging in my office: